This section will guide you through the process of unpacking your miniSMU MS01 for the first time and performing an initial inspection. Following these steps carefully will help ensure that your device is in good condition and ready for setup.

Unpacking Procedure

1. Prepare a Clean Workspace

   • Clear a flat, clean surface with adequate space for unpacking
   • Ensure the area is free from liquids, static-generating materials, and debris
   • Have good lighting available to inspect components

2. Open the Shipping Box

   • Cut tape or seals carefully without damaging the contents
   • Open the box and remove the top layer of protective packaging

3. Remove the Device and Accessories

   • Carefully lift the miniSMU MS01 from its protective packaging
   • Remove all accessory boxes and packages
   • Place all components on your prepared workspace
   • Set aside all packaging materials for later storage or transport

4. Locate Documentation

   • Find the quick start guide link
   • Review the packing list to confirm all items are present

Inventory Checklist

Check that all of the following items are included in your package:

If any items are missing, please contact our customer support immediately before proceeding.

Visual Inspection

Perform a thorough visual inspection of the miniSMU MS01 and its accessories:

Device Inspection

1. Examine the Enclosure

   • Check for any visible damage, dents, or scratches
   • Ensure the case is securely assembled without loose parts

2. Inspect the Front Panel

   • Verify the BNC connectors are undamaged and properly aligned
   • Check that the status LEDs are intact
   • Ensure the cooling vents are clear and undamaged

3. Inspect the Rear Panel

   • Check that the power switch moves freely
   • Verify the USB-C port is clean and undamaged
   • Ensure the DC power input is intact
   • Check that the WiFi antenna connector is undamaged
   • Confirm the user button is intact and not stuck

4. Check the Bottom and Sides

   • Ensure all rubber feet are present and securely attached
   • Verify there are no loose parts inside (listen for rattling)
   • Check that all labels are legible and properly attached

Accessories Inspection

1. Power Adapter

   • Check for any damage to the adapter housing
   • Examine the cable for cuts, fraying, or kinks
   • Inspect the connector for bent pins or damage

2. USB-C Cable

   • Verify both ends of the cable are undamaged
   • Check the cable for cuts or kinks
   • Confirm the connectors are clean and free from debris

3. WiFi Antenna

   • Ensure the antenna is straight and undamaged
   • Check that the connector threads are clean and undamaged

4. BNC Adapters

   • Verify all adapters are present and undamaged
   • Check that the connectors are clean and free from debris

Documentation Verification

1. Calibration Certificate
   • Verify that the serial number on the certificate matches the number on your device
   • Confirm that all calibration parameters are within specification

What to Do If You Find Damage

If you discover any damage or missing items during your inspection:

1. Take clear, well-lit photographs of any damage
2. Do not attempt to use damaged equipment
3. Retain all original packaging
4. Contact our customer support immediately with:
   • Your order number
   • Device serial number
   • Description of the damage or missing items
   • Photos of the damage

Preparing for Setup

After successfully unpacking and inspecting your miniSMU MS01:

1. Keep the original packaging for potential future transportation needs
2. Allow the device to acclimate to room temperature if it was shipped in cold conditions
3. Read through the safety information in the user manual before proceeding
4. Proceed to the Power Supply Options section to begin setting up your device

By thoroughly inspecting your miniSMU MS01 before use, you can ensure it's in optimal condition and ready for years of reliable service.